Recommendations for installing your GreenAgric Micro Tunnel ...

Congratulations on purchasing your ...
GreenAgric Economical Micro Growing Tunnel ...

* You will receive Support Poles and a bag containing 3 pieces of Shade Cloth, plus a nylon cord and cable ties

  
For 2 meter tunnels you will receive 2 Support Poles
  
For 4 meter tunnels you will receive 3 Support Poles
 
 
For 6 meter tunnels you will receive 4 Support Poles
  
For 8 meter tunnels you will receive 5 Support Poles
   For 10 meter tunnels you will receive 6 Support Poles
   For 12 meter tunnels you will receive 7 Support Poles
  
For 16 meter tunnels you will receive 9 Support Poles
   For 20 meter tunnels you will receive 11 Support Poles
   For 26 meter tunnels you will receive 14 Support Poles
  
For 30 meter tunnels you will receive 16 Support Poles


* Firstly insert the inner support poles, the ones that are NOT at both ends of your tunnel, by slotting one end over a Y Standard, then bending the pole to slot in the other corresponding side … width ways … Please note that this is usually a two person exercise …

* Now thread one end of the shade cloth onto one of the end support poles, then slot one end of the support pole over a Y Standard, then bend the pole to slot in the other corresponding side … again width ways …

* Now pull the shade cloth
over the inner support poles, then thread the end onto the final support pole … again slot one end onto the Y Standard, then bend the pole to slot in the other end … again width ways …

* The ends of the support poles should be 5cms to 10 cms below ground level … this will ensure that the ends of shade cloth will also be below ground level ...

* Taking one of the end pieces of shade cloth, start attaching it with the cable ties to an end support pole and main shade cloth
in the middle and then work sideways … it is important that you keep the end pieces of shade cloth square as you attach themstretch the shade cloth as you attach it ...

* Now do the same at the other end …

* At the one end of the tunnel create your doorway, by attaching an outer and inner wooden door frame in the centre … and securing it at the top to the support pole and to a wooden pole beneath ground level at the bottom … this can be constructed using rough inexpensive timber ...

* Take the nylon cord and attach it below ground level to one of the support poles, all around the tunnel … when you pass a Y Standard, pull the cord and wrap it around the Y Standard … contnue to do this all around the tunnel ...

* Staple the end shade cloth piece to the inner and outer wooden door frames … once you have done this make a cut on the shade cloth between the wooden inner and outer frames …

* Back fill your perimeter trench … now stand back and admire your tunnel !!! …
then please take a few photos and send them to me ...

Should you need any further help with the installation of your tunnel, please do not hesitate to call me as many times as is required …

Good Luck !!! …

Kind regards
Pete Moore
GreenAgric
Cell : 072 387 2293
also available on WhatsApp and Messenger
as well as on Facebook
and soon on Duo
Email : PeteMoore@GreenAgric.co.za

Open 7 to 7 - 7 days a week

 

 What's included in the DIY Kit ...
* Internally Reinforced Support Poles ...
* 20% or 40% White Titanium Shade Cloth ... depending on what your ordered ...
* Cords to be used in the installation of your tunnel ...

What's not included in the DIY Kit ...
* Y Standards ...
* Doorways ...
* Irrigation ...
* Mulch and Compost ...
* Seeds and Seedlings ...
* Pest and Anti Fungi Sprays ...